View Single Post
Old 09-19-2017, 03:46 AM   #3
Breel
Registered User
 
Join Date: May 2016
Location: Point Loma, SD, CA
Posts: 45
Re: First time Roller build

I'm glad you caught that, because I didn't! So my fix is to plane the sides down even. There should be enough room for the double rollers being that the difference is only .4". I had it setup so the sides of the roller pockets had plenty of thickness. Or I could add another piece of wood to the thinner part and plane it to the size of the head. The gap is small enough to were the wood should still pass by it along the fence without getting hung up. You can see that I add some width to the front of the blank in the picture of it hanging. Then again I could be completely wrong. Again thanks for noticing rookie mistake

Last edited by Breel; 09-19-2017 at 06:05 AM.
Breel is offline   Reply With Quote